Removing And Installing Clutch Pedal (Octavia Ii) - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Octavia III 2013 ➤ , Octavia III ...
Gearbox 0AF - Edition 09.2013
– If present, unhook the tension spring -1- and remove, while
doing so pull the clutch pedal in -direction of arrow A-.
– Put the clutch pedal back into the home position.
– Pull the clutch pedal in -direction of arrow A-, unhook the over-
centre helper spring -2- and remove.
Install
The installation is performed in the reverse order, pay attention
to the following points:
• The bearing shells -arrows- of the bolts -1- are installed.
– Pull the clutch pedal in -direction of arrow A- (⇒ previous fig‐
ure) into the passenger compartment.
– Inser the bolt -1- into the mount -2- of the carrier.
– Insert the bearing -3- into the mount -4- for the clutch pedal.
• If the clutch pedal is pressed in -direction of arrow B- (⇒ pre‐
vious figure),the over-centre helper spring springs in direction
of carrier.
– Press the clutch pedal in -direction of arrow B- (⇒ previous
figure), until the over-centre helper spring engages in direction
of carrier.
– Connect the tappet for master cylinder with the clutch pedal,
to do so use the new carrier bolt ⇒ Electronic catalogue of
original parts .
– Insert crash strut -1- and tighten screw -2- ⇒ Body Work; Rep.
gr. 70 .
– Install data bus diagnostic interface - J533- ⇒ Electrical Sys‐
tem; Rep. gr. 97 .
– Install footwell vent driver's side ⇒ Heating, Air Conditioning;
Rep. gr. 87 .
Vehicles with knee airbag
– Install knee airbag driver's side, in case it was removed ⇒
Body Work; Rep. gr. 69 .
Vehicles without knee airbag
– Connect battery ⇒ Electrical System; Rep. gr. 27 .
1.9 Removing and installing clutch pedal
(Octavia II)
Special tools and workshop equipment required
♦ Pliers - T10005-
♦ Release tool - T10178-
24
Rep. gr.30 - Clutch