Chrysler DODGE D150 1993 Service Manual page 1140

• IN-VEHICLE SERVICE-32RH/36RH/37RH/42RH/46RH 21 - 139
(7) Push solenoid connector out of case.
(8) Remove valve body attaching screws.
(9) Lower valve body enough to remove accumula­
tor piston and piston spring (Fig. 2 4 ) .
(10) Pull valve body forward to disengage park rod.
(11) Push manual lever shaft and solenoid case
connector out of transmission case. Lower valve body,
rotate it away from case, pull park rod out of sprag
and remove valve body (Figs. 25 and 26).
ACCUMULATOR OUTER
PISTON SPRING
INNER SEAL
SPRING RINGS J932M87
Fig. 24 Accumulator Piston And Springs (42RH/
46RH Shown)
Fig. 25 Valve Body Assembly—4-Speed Transmission
VALVE BODY INSTALLATION
(1) Verify that park/neutral position switch has
N O T been installed. Valve body cannot be installed
with switch in place. Remove switch if necessary.
(2) Install new seals on accumulator piston and in­
stall piston in case.
(3) Place valve body manual lever in low (1 posi­
tion) to ease installing park rod in sprag.
(4) Use screwdriver to push park sprag into en­
gagement with park gear. This allows knob on rod to
MANUAL CONVERTER
LEVER CLUTCH
- Fig. 26 Valve Body Assembly—3-Speed
Transmission
move past sprag when valve body is installed. Rotate
output shaft to verify sprag engagement.
(5) Position accumulator spring between accumula­
tor piston and valve body.
(6) Position valve body on transmission and work
park rod past sprag. Be sure accumulator piston and
spring remain in position.
(7) Hold valve body in position and install valve
body attaching screws linger tight only.
(8) Install park/neutral position switch in case.
(9) Tighten valve body attaching screws alter­
nately and evenly to 11 N # m (100 in. lbs.) torque.
(10) Install new fluid filter on valve body. Install
and tighten filter screws to 4 N-m (35 in. lbs.) torque.
(11) Connect solenoid wire to case connector.
(12) Install manual and throttle levers on throttle
lever shaft. Tighten lever clamp screws and check for
free operation. Shaft and levers must operate freely
without any bind.
(13) Install oil pan and new gasket.
(
Tighten pan
bolts to 17 N»m (150 in. lbs.) torque.
(14) Connect park/neutral position switch and con­
verter clutch solenoid wires.
(15) Install speedometer pinion gear, adapter and
speed sensor.
(16) Lower vehicle.
(17) Fill transmission with Mopar ATF Plus, Type
7176, or Dexron II™ fluid if ATF Plus is not readily
available.
(18) Adjust gearshift and throttle linkage.