Chrysler DODGE D150 1993 Service Manual page 1339

OVERDRIVE UNIT OVERHAUL—42RH/46RH

(30) Install direct clutch pack snap ring (Fig. 54).

Be v e r y s u r e s n a p r i n g Is fully s e a t e d In c l u t c h

d r u m r i n g g r o o v e .

(31) Install clutch h u b retaining ring (Fig. 55). B e

v e r y s u r e r e t a i n i n g r i n g Is fully s e a t e d i n s u n

g e a r r i n g g r o o v e .

(32) Slowly release press ram, remove compressor

tools and remove geartrain assembly.

Fig. 54 Installing Direct Clutch Pack Snap Ring

Fig. 55 Installing Clutch Hub Retaining Ring

OVERDRIVE UNIT ASSEMBLY AND ADJUSTMENT

(1) Install front bearing and snap ring on output

shaft (Fig. 56). B e s u r e l o c a t i n g r i n g g r o o v e i n

b e a r i n g is t o w a r d r e a r of shaft.

(2) Install governor drive key in output shaft (Fig.

(3) Install new seal rings on governor drive. Be

sure ring ends are securely interlocked before pro

ceeding (Fig. 57).

(4) Assemble governor drive and body. Be sure fil

ter is properly seated and positioned in governor

body before tightening attaching bolts.

(5) Assemble governor inner and outer weights

and spring. Then install weight assembly in governor

Fig. 56 Front Bearing And Drive Key Installation

Fig. 57 Governor Drive Seal Rings

Fig. 58 Installing Governor Weight Assembly

body (Fig. 58). Be sure all retaining snap rings are

securely seated.

Show Quick Links