Chrysler DODGE D150 1993 Service Manual page 1418

• BODY COMPONENTS 23 - 35
CAB/BODY INTERIOR COMPONENTS
INDEX
page
Carpets and Floor Mats 51
Floor Console and Rear Storage Tray . . . . . . . . . 50
Front Seats 3 8
Headliners 48
Instrument Panel 3 5
page
Interior Trim Panels . 4 2
Rear Seats 41
Shoulder Belts/Lap Belt/Buckles 4 5
Spare Tire Carrier 4 5
INSTRUMENT PANEL
INSTRUMENT CLUSTER BEZEL
REMOVAL
(1) Remove the bezel screws.
(2) Remove the bezel from the instrument panel.
INSTALLATION
(1) Position the bezel on the instrument panel.
(2) Install t h e bezel screws. Tighten the screws to
2 Nnn (17 in. lbs.) torque.
INSTRUMENT
PANEL
EDGE
TRIM
4WD
INDICATOR
COVER
4WD)
INSTRUMENT
CLUSTER
BEZEL SCREW
Fig. 11nstrument Cluster Bezel Removal/Installation
INSTRUMENT CLUSTER AND/OR IP
COMPONENT
REMOVAL
(1) Remove the instrument cluster bezel screws
(Fig. 1). Remove the bezel from the instrument
panel.
(2) As applicable, remove the instrument cluster or
other IP component screws (Fig. 2).
(3) Disconnect the wire harness connector(s) from
the IP cluster or component. Refer to Group 8—Elec­
trical for additional information.
(4) If applicable, disconnect the shift position indi­
cator from t h e steering column (Fig. 3).
(5) Remove the IP cluster or component from the
instrument panel.
INSTALLATION
(1) Position the IP cluster or component at t h e in­
strument panel. Connect t h e wire harness connec­
tors).
(2) Install t h e cluster or component in the instru­
ment panel (Fig. 2).
(3) If applicable, connect t h e shift position indica­
tor to the steering column (Fig. 3).
(4) Install the IP cluster or component screws.
Tighten the screws to 2 N # m (17 in. lbs.) torque.
(5) Position the bezel on t h e instrument panel.
(6) Install t h e bezel screws. Tighten t h e screws to
2 Nnn (17 in. lbs.) torque.
INSTRUMENT
PANEL
LAMP
ACC
SWITCH
BEZEL
HEADLAMP
SWITCH
HEADLAMP
SWITCH
A N D POWER
MIRROR
CONTROL
BEZEL
SCREW
INSTRUMENT
J 9 1 2 3 3 5 1
CLUSTER J9123-351
Fig. 2 Instrument Cluster Removal/Installation
A/T SHIFT POSITION (PRNDL) INDICATOR
REMOVAL
(1) Disconnect the shift position (PRNDL) indicator
cable from t h e steering column.
(2) Remove the indicator screws from t h e rear of
the instrument cluster.
(3) Remove the indicator from the instrument clus­
ter.