Chrysler DODGE D150 1993 Service Manual page 1465

24 - 28 HEATING AND AIR CONDITIONING —
J8924-40
Fig. 24 Waive Plate
(5) Visually inspect the rear valves and discharge
retainer for damage. Discard any component if any
portion is damaged.
If valve plate and/or cylinder head are to be reused,
carefully remove gasket materials using the gasket
scraper. Do not damage cylinder block or valve plate
surfaces.
. . . _ #
E8924-207
Fig. 25 Cylinder Head Bolt Torque Sequence
INSTALLATION
When installing the cylinder head valve plate, use
the new gaskets in the parts kit.
(1) Coat new valve plate gasket with clean refrig­
erant oil.
(2) Install valve plate gasket by aligning valve
plate gasket to locating pin holes and oil orifice in
cylinder block. (For easy reference, the gaskets have
a notch at the bottom outside edge).
(3) Install valve plate by aligning valve plate lo­
cating pins to the pin holes in the block and position
valve plate.
(4) Install cylinder head and tighten bolts in order
to 32 N*m (24 ft. lbs.) torque (Fig. 25).
(3) Visually inspect all parts for damage.
(4) Separate the valve plate from the cylinder
block (Fig. 24).