Chrysler DODGE D150 1993 Service Manual page 1497

25 - 20 EMISSION CONTROL SYSTEMS
•
engine and tighten to 14 N*m (130 in. lbs.) torque.
Install electrical connector to sending unit.
(5) Clean the intake manifold and EGR valve of
any old gasket material.
(6) Install a new EGR valve gasket to intake man­
ifold.
(7) Install EGR valve to intake manifold. Tighten
two mounting bolts to 23 N*m (200 in. lbs.) torque.
(8) Install vacuum lines to EGR valve.
(9) Install spark plug cable loom and plug cables to
valve cover mounting stud.
(10) Install air filter housing.
ELECTRIC EGR TRANSDUCER (EET)
The EGR valve and the EET are serviced as one
unit. Also refer to EGR valve removal/installation.
REMOVAL
(1) Remove air filter housing.
(2) Disconnect wiring connector at EET (Fig. 8).
(3) Disconnect hoses at EET. Note position of hoses
for easier installation.
(4) Remove EET from engine.
INSTALLATION
(1) Position EET to engine and connect hoses.
(2) Connect wiring connector.
(3) Install air filter housing.
ELECTRICAL
CONNECTOR
TRANSDUCER
J9325-15
Fig. 8 Electric EGR Transducer (EET)—Typical
EVAP CANISTER
The EVAP canister is mounted in the engine com­
partment on the right side wheel well (Fig. 9).
REMOVAL
(1) Remove fuel tubes/lines at EVAP canister.
Note location of tubes/lines before removal for easier
installation.
(2) Remove mounting bolt at canister mounting
strap (Fig. 9).
(3) Remove canister and two-piece strap from
mounting bracket.
CANISTER
M O U N T I N G
STRAPS
CANISTER
M O U N T I N G
BRACKET
RIGHT FRONT
INNER FENDER
MOUNTING
BOLT
EVAP
CANISTER
J9325-36
Fig. 9 EVAP Canister Removal/Installation
INSTALLATION
(1) Position canister to mounting bracket.
(2) Install canister and both mounting straps to
mounting bracket.
(3) Install canister bolt and tighten to 10 N*m (95
in. lbs.) torque.
(4) Install fuel tubes/lines to canister.
EVAP CANISTER PURGE SOLENOID
REMOVAL
(1) Remove air filter housing.
(2) Disconnect wiring connector at solenoid (Fig.
10).
BRACKET MOUNTING
NUT
ELECTRICAL
CONNECTOR
CANISTER PURGE
SOLENOID/BRACKET
VACUUM
CONNECTOR
J9214-50
Fig. 10 EVAP Canister Purge Solenoid— Typical
(3) Disconnect vacuum harness at solenoid (Fig.
10).