Chrysler DODGE D150 1993 Service Manual page 1217

2 1 - 2 1 6 TRANSMISSION OVERHAUL—36RH/37RH
Fig. 81 Installing Driving Shell Thrust
Washer-36RH/37RH
Fig. 82 Installing Thrust Washer On Front Planetary
Gear—36RH/37RH
(11) Install front annulus gear over and onto front
planetary gear (Fig. 83). Be sure gears are fully
meshed and seated.
(12) Install front planetary and annulus gear as­
sembly (Fig. 84). Hold gears together and slide t h e m
onto shaft. Be sure planetary pinions are seated on
sun gear and t h a t planetary carrier is seated on out­
put shaft.
•
Fig. 83 Assembling Front Planetary And Annulus
Gears—36RH/37RH
Fig. 84 Installing Front Planetary And Annulus Gear
Assembly-36RH/37RH
(13) Place geartrain in upright position. Rotate
gears to be sure all components are seated and prop­
erly assembled. Snap ring groove at forward end of
output shaft will be completely visible when compo­
nents are correctly assembled.
(14) Install planetary snap ring in groove at end of
output shaft (Fig. 85).
(15) Turn planetary geartrain over. Position wood
block under front end of output shaft and support
TAB DRIVING