Chrysler DODGE D150 1993 Service Manual page 1476

•
HEATING AND AIR CONDITIONING
24 - 39
LOU¥ER ASSEMBLIES
REMOVAL
(1) Remove faceplate.
(2) Set faceplate with trim surface down, insert a
small screwdriver tip into the outlet housing pivot
hole.
(3) While forcing down louver assembly pivot pin,
pull louver assembly out of rear of faceplate (Fig. 9).
INSTALLATION
(1) Position louver assembly, bottom pivot first,
into t h e faceplate outlet housing. The bottom pivot
pin is a smaller diameter t h a n the top pivot pin.
(2) While deflecting the upper louver assembly
pivot pin, carefully swing the assembly into housing,
so the felt pads are not damaged. Ensure top and bot­
tom pivot pins are properly engaged.
(3) Install faceplate.
TORQUE SPECIFICATIONS
D E S C R I P T I O N f O R Q U E
D E S C R I P T I O N
Compressor (SD-709)
Cylinder Head Bolts 32 N-m (24 ft. lbs.)
Magnetic Clutch Hex Nut... 37 N-m (27 ft. lbs.)
Mounting Bolts 27 N-m (20 ft. lbs.)
Oil Filter Plug
10 N-m (7 ft. lbs.)
Service Valve-to-Compressor Fitting* ........ 47 N-m (35 ft. lbs.)
T O R Q U E
H-Valve Control Head Torx
Drive Bolts 11 N-m (100 in. lbs.)
H-Valve Plumbing Sealing Plate Bolt 23 N-m (200 in. lbs.)
Refrigerant Cans-to-Manifold Gauge
Set Nuts 9.5 N-m (7 ft. lbs.)
•Wet Torque - Lubricate the service valve coupling threads and O-rings with
compressor oil.
J9324-100