Chrysler DODGE D150 1993 Service Manual page 1424

• BODY COMPONENTS 23 - 41
RELEASE
SCREW TRACK J 9 1 2 3 " 3 3 5
Fig. 17 Left Seat Tracks
A R M R E S T INSTALLATION
(1) Position the armrest pivot support bracket on
the seatback.
(2) Install the screws in the seatback. Tighten the
screws to 23 N*m (200 in. lbs.) torque.
(3) Position the armrest on the pivot support
bracket.
(4) Install the armrest screw in the pivot support
bracket. Tighten the screw to 11 N*m (100 in. lbs.)
torque.
SEAT BACK SEAT
Fig. 18 Armrest Removal/Installation
REAR SEATS
JUMP SEAT-CLUB CAB
R E M O V A L
(1) Remove the cab side trim panel.
(2) Remove the nuts from the studs. Pull outward.
Remove the backrest from the cab side panel support
brackets.
(3) Raise and support the vehicle. Remove the
jump seat hinge stud nuts from the under side of the
cab.
(4) Remove the support. Lower the vehicle. Re­
move the jump seat cushion from the cab.
INSTALLATION
(1) Position the backrest at the cab side panel. In­
stall the nuts. Tighten them to 4 N*m (35 in. lbs.)
torque.
(2) Install the cab side trim panel.
(3) Position the seat cushion in the cab.
(4) Raise and support t h e vehicle. Install the nuts
on the hinge studs. Tighten the nuts to 23 N
#
m (200
in. lbs.) torque.
(5) Remove the support. Lower the vehicle.
SIDE BACK REST
Fig. 19 Jump Seat Removal/installation
FOLDING HEAR SEAT-RAMCHARGER
The instructions for operating the folding rear seat
mechanism is included in the owners manual. This
manual is included with the vehicle.
R E M O V A L
(1) For convenience, raise and support the vehicle.
(2) Remove the nuts and washers from the seat
front hinge studs (Fig. 20).
(3) Remove the support. Lower the vehicle.
(4) Release the seat cushion rear latches from the
strikers (Fig. 20).
(5) Remove the folding seat from the vehicle.