Chrysler DODGE D150 1993 Service Manual page 1425

23 - 42 BODY COMPONENTS
•
(6) If necessary, remove the seat cushion hinges.
Remove the torsion bar and armrests. Remove the
armrest supports and seatback hinges from the seat
(Figs. 22 and 23).
INSTALLATION
(1) If applicable, install the seat cushion hinges.
Install the torsion bar and armrests. Install the arm­
rest supports and seatback hinges on the seat.
(2) Position the folding seat in the vehicle. Engage
the seat cushion rear latches with the strikers.
(3) For convenience, raise and support the vehicle.
(4) Install the washers and nuts on the seat front
hinge studs. Tighten the nuts to 11 N»m (95 in. lbs.)
torque.
(5) Remove the support. Lower the vehicle.
Fig. 20 Folding Rear Seat
INTERIOR TRIM PANELS
SERVICE INFORMATION
Ram Truck, Chassis Cab and Ramcharger interior
trim panels are comprised of the:
• Windshield header trim panel
• Door header trim panels
• A-pillar trim panels
• Cowl side trim panels
• Rear corner trim panels
• Quarter window trim panels
• Rear window upper trim panel
RD156
Fig. 21 Folded Seatback
V l t w I I N DIRECTION OF ARROW D
DIRECTION OF ARROW C
SEAT CUSHION
Fig. 22 Folding Seat Cushion Hinges & Torsion Bar
• Rear window lower trim panel
• Rear header (hatchgate) trim panel
§ Lower side trim panels
• Seat belt retractor covers
All the interior trim panels are attached with
screws and/or clip retainers.
C A U T I O N : Remove overlapping panels before re­
moving inboard trim panels. Also verify that all
screws and retainer clips are removed before re­
moving a trim panel. Trim panels are somewhat
flexible but can be damaged if handled improperly.
Install the screws finger-tight, align the panels at
each end and then tighten the screws. U s e care to
avoid overtightening the s c r e w s or, otherwise,
the trim panels will be damaged.