Chrysler DODGE D150 1993 Service Manual page 1180

TRANSMISSION OVERHAUL—32RH 21 - 171
E-CLIP SHUTTLE
VALVE
Fig. 102 Shuttle Valve E-Clip And Secondary Spring
Location—32RH
(25) Remove 2-3 shift valve and spring from valve
body (Fig. 104).
(26) Remove 1-2 shift valve and spring from valve
body (Fig. 104).
(27) Remove regulator valve end plate (Fig. 104).
(28) Remove regulator valve line pressure plug,
pressure plug sleeve, throttle pressure plug and
spring (Fig. 104).
VALVE BODY CLEANING AND INSPECTION
The only serviceable valve body components are:
• park lock rod and E-clip
• switch valve and spring
• pressure adjusting screw bracket
• throttle valve lever
• manual shaft
• manual shaft seal, washer, E-clip and detent ball
• fluid filter.
• converter clutch solenoid
The remaining valve body components are serviced
only as part of a complete valve body assembly.
Clean the valve body components in a parts clean­
ing solution only. Do not use gasoline, kerosene, or
any type of caustic solution. Dry t h e parts with com­
pressed air. Make sure all passages are clean and
free from obstructions.
D o not u s e rags or s h o p towels to w i p e off
valve body components. Lint from these materi­
als will adhere to the valve b o d y components.
Lint will interfere with valve operation a n d m a y
clog filters a n d fluid p a s s a g e s .
Inspect the throttle and manual valve levers and
shafts. Do not attempt to straighten a bent shaft or
correct a loose lever. Replace these components if
worn, bent, loose or damaged in any way.
Inspect all of t h e valve body mating surfaces for
scratches, nicks, burrs, or distortion. Use a straight-
SHUTTLE
VALVE
END PLATE
SWITCH
VALVE
LINE
PRESSURE
REGULATOR
VALVE
SECONDARY
SPRING & GUIDES
SHUTTLE
VALVE
PRIMARY
SPRING
SHUTTLE
VALVE
THROTTLE
PLUG
GOVERNOR
PLUG-
END PLATE
J9121-50
Fig. 103 Control Valves And Governor Plugs—32RH