Chrysler DODGE D150 1993 Service Manual page 1397

23 - 14 BODY COMPONENTS
H O U S I N G U-NUT CARGO BOX
FWD HOSE CLAMP J9123-551
Fig. 37 Fuel Filler Housing & Nozzle/Tubes
INSTALLATION
(1) If necessary, clean the door panel-mirror base
contact surface.
(2) If separated, attach the mirror to the base.
Tighten the stud-nut to 11 N-m (95 in. lbs.) torque.
(3) Position the mirror base on the door outside panel
with its screw holes aligned with the panel holes.
(4) Install the mirror base screws. Tighten the
screws to 4 N-m (35 in. lbs.) torque.
LOCKWASHER OUTSIDE REINFORCEMENT
PLATE
61/2 x 9 IN. MIRROR
MANUAL MIRROR MANUAL OR POWER
J9123-332
Fig. 38 Standard&6X9 Wide-View Mirrors
6X9 WIDE-VIEW MIRROR
R E M O V A L
(1) Remove the mirror cover screw. Separate the
mirror cover from the base.
(2) Remove the mirror base nuts from the rein­
forcement plate studs.
(3) Remove the mirror and the base from the door
outside panel.
(2) Position the mirror base on the door outside panel
with the studs inserted in the mirror base holes.
(3) Install the mirror base nuts. Tighten the nuts
to 11 N-m (95 in. lbs.) torque.
(4) Position the cover over the mirror base.
(5) Install the cover screw. Tighten the screw to 2
N-m (17 in. lbs.) torque.
LOW PROFILE OUTSIDE MIRROR
R E M O V A L
(1) Remove the bolts t h a t attach the support
braces to the door outer panel.
(2) Remove the mirror and braces from the door
outer panel.
INSTALLATION
(1) Position the mirror and braces on the door
outer panel with the brace holes aligned with the n u t
inserts.
(2) Install the mirror brace bolts in the nut inserts.
Tighten the bolts to 11 N-m (95 in. lbs.) torque.
WASHER
Fig. 39 Low Profile Mirror
CAB
SERVICE INFORMATION
The cab is attached to the vehicle frame structure
with bolts (Figs. 40 and 41). If necessary, the cab can
be removed for repair or service access. Refer to the
procedure within Group 13—Frame.
TAILGATE
REMOVAL
(1) Open the tailgate.
(2) Separate the tailgate check arms from the pins.
Separate the check arms from the tailgate (Fig. 42).
• Single wheel vehicles: On the right side, remove
the tailgate hinge-half from the slot in cargo box
I N S T A L L A T I O N
(1) If necessary, clean the door panel-mirror base
contact surface.