Chrysler DODGE D150 1993 Service Manual page 1416

•
BODY COMPONENTS 23 - 33
Fig. 12 Quarter Window Exterior Mouldings
INSTALLATION
(1) Remove the residual butyl tape from the win­
dow opening. If the original glass will be installed,
remove all the residual butyl tape from the glass.
(2) Apply primer to the glass and allow 10 minutes
for it to dry. Avoid contact with the primed surface.
(3) Inspect the quarter window spacers for correct
installation (Fig. 13).
(4) Apply butyl tape to the entire edge of the win­
dow flange (Fig. 14).
SECTION A-A SECTION B-B
Fig. 14 Butyl Tape Installation
(5) Remove excess tape and butt the tape-ends
firmly together.
(6) Install the quarter window glass on the butyl
tape (Fig. 15)
(7) Force the glass against the butyl tape to obtain
a good seal (Fig. 15).
(8) Test the quarter window glass for water leaks.
(9) If leakage occurs, additional sealing will be re­
quired. Use an appropriate windshield sealer (Fig.
16).
(10) Install the exterior mouldings.
(11) Install the interior trim panel.
(12) Clean the glass.