Chrysler DODGE D150 1993 Service Manual page 1073

21 - 72 G36Q TRANSMISSION OVERHAUL
missions were not originally equipped with a cover
gasket, a gasket should be installed on these trans­
missions).
(7) Verify t h a t synchronizer sleeves are in neutral
position. Shift cover cannot be installed otherwise.
(8) Install shift cover. Align shift forks with syn­
chro sleeves and alignment dowels and seat cover on
case.
(9) Apply Mopar or Loctite thread locker to shift
cover bolts. Then install and tighten bolts to 22-30
N-m (16-22 ft. lbs.) torque.
(10) Place transmission in level position and in­
stall drain plug. Tighten plug to 47 N-m (35 ft. lbs.)
(11) Fill transmission to bottom edge of fill plug
hole with Mopar 5W-30 engine oil.
(12) Install and tighten fill plug to 47 N-m (35 ft.
lbs.) torque.
(13) Install backup light switch in shift cover if re­
moved.
(14) Mount transmission on jack for installation in
vehicle.
(15) Secure transmission to jack with safety
chains.
(16) Apply thin coat of Mopar high temperature or
multi-purpose grease to pilot hub of input shaft.