Chrysler DODGE D150 1993 Service Manual page 1252

_ TRANSMISSION 0VERHAUL-42RH

DRIVING SHELL

FRONT THRUST

INTERMEDIATE

SHAFT THRUST

INTERMEDIATE

Fig. 69 Transmission Planetary Gear Train—42RH

(1) Lubricate intermediate

components with transmission fluid. Use petroleum

jelly to lubricate and hold thrust washers and plates

in position.

(2) Assemble rear annulus gear and support if dis

assembled. Be sure support snap ring is seated and

t h a t shoulder side of support faces rearward.

(3) Install rear thrust washer on rear planetary

gear (Fig. 70). Use enough petroleum jelly to hold

washer in place. Also be sure washer tabs are prop

erly engaged in gear slots.

(4) Install rear annulus over and onto rear plane

tary gear (Fig. 70).

(5) Install assembled rear planetary and annulus

gear on intermediate shaft (Fig. 71). Verify t h a t as

sembly is fully seated on shaft.

(6) Install front thrust washer on rear planetary

gear (Fig. 72). Use enough petroleum jelly to hold

washer on gear.

(7) Install spacer on sun gear (Fig. 73).

(8) Install thrust plate over sun gear and on top of

spacer (Fig. 74). Note t h a t thrust plates are inter

changeable. Use either plate on sun gear and rear of

driving shell.

J 9 1 2 1 - 1 5 6

Fig. 70 Assembling Rear Annulus And Planetary

(9) Insert sun gear into driving shell (Fig. 75).

(10) Hold sun gear in position and install rear

thrust plate. Plate goes over sun gear at rear of driv

ing shell (Fig. 75).

Show Quick Links