Chrysler DODGE D150 1993 Service Manual page 1414

•
BODY COMPONENTS 23 - 31
WEATHERSTRIP
SEAL
VENT
GLASS
AND FRAME
SCREW
RIVET-NUT
RETAINER
J9123-340
Fig. 5 Vent Window Removal/installation
(2) Separate the seal lip from the glass at one cor­
ner with a trim stick. Carefully push the glass out of
the seal (Fig. 8).
(3) Force the glass out of the weatherstrip seal. Re­
move it from the seal and the window opening.
(4) Remove the weatherstrip seal from the window
opening.
INSTALLATION
(1) Clean the seal channels and the window
flanges in the cab.
(2) Install the seal on the window glass or frame.
(3) Apply a 6-mm (1/4-in) diameter bead of sealant
to the window flange.
(4) Install the glass according to the following in­
structions:
• Moisten a length of 6-mm (1/4-in) diameter cord
with a soap and water solution
• Verify t h a t the cord is long enough to go around
the edge of the seal.
• Insert the cord into the window flange in the seal
(Fig. 9)
• Position the window and seal in the opening with
the free ends of the cord inside t h e vehicle
• Pull on the cord ends. Pull t h e seal channel lip
over the window flange.
(5) Test the window for water leaks.
(6) As applicable, install the window reveal moul­
ding or retainer.
(7) Clean the vehicle, as necessary.
SLIDING WENT GLASS
REMOVAL
(1) Remove the complete rear window from the cab
opening. If necessary, refer to the removal procedure.
(2) Place the frame and glass on a clean, padded
area.
(3) Loosen the screws located on the bottom of the
frame.
CAB
BACK
PANEL
WEATHERSTRIP
SEAL
SLIDING
GLASS
A N D FRAME
RETAINER
Fig. 6 Cab Rear Windows
CAB
PANEL WEATHERSTRIP SEAL
WITH
MOULDING
WEATHERSTRIP
SEAL
RETAINER
FIXED
W I N D O W
GLASS
WEATHERSTRIP SEAL
' WITH MOULDING
CAB
BACK
PANEL
RETAINER
CAP
RETAINER
<tOF W I N D O W
LOWER
WEATHERSTRIP
SEAL
UPPER
FIXED
GLASS
J9123-339
CAB
BACK
PANEL
FIXED
W I N D O W
GLASS
SLIDING
GLASS
A N D FRAME
J9123-338
Fig. 7 Rear Window
Glass/Frame—Removal/Installation
PU866
Fig. 8 Rear Window Removal— Typical
(4) Carefully spread the frame apart.
(5) Remove the sliding vent glass from the frame
track.