Chrysler DODGE D150 1993 Service Manual page 1429

23 - 46 BODY COMPONENTS
•
(3) Bucket seats—detach the covers from the an­
chor bolts for the left and right shoulder belt buckles.
(4) Remove the anchor bolts from the anchor plates
on the floor panel.
(5) Remove the buckles and the lap belt from the
floor panel.
• Ram Trucks and Chassis Cabs—Remove the cover
concealing the shoulder belt upper anchor bolt.
• Ramchargers—Remove the quarter window trim
panel. If necessary, refer to the removal procedure.
(6) Remove the upper anchor bolt from the cab in­
ner side panel/B-pillar.
• Ram Trucks and Chassis Cabs—Remove the shoul­
der belt retractor and lower anchor bolt from the
B-pillar.
• Ramchargers—Remove the screw and belt retrac­
tor cover from the side inner panel. Remove the an­
chor bolts. Remove the retractor and lower belt from
the side inner panel.
(7) Remove the shoulder belts and retractors from
the vehicle.
INSTALLATION
(1) Position the shoulder belt retractor and the
lower end of the shoulder belt at the side inner
panel. Align the anchor bolt holes. Install the anchor
bolts. Tighten the anchor bolts to 40 N*m (350 in.
lbs.) torque.
• Ramchargers—Install the belt retractor cover and
the screw in the side inner panel. Tighten the screw
to 1 N»m (12 in. lbs.) torque.
(2) Position the shoulder belt upper anchor plate
on the trim panel. Install the upper anchor bolts in
the side panels. Tighten the anchor bolts to 40 N # m
(350 in. lbs.) torque.
• Ram Trucks and Chassis Cabs—Install the cover
to conceal the shoulder belt upper anchor bolt.
• Ramchargers—Install the quarter window trim
panel. If necessary, refer to the installation proce­
dure.
(3) Position the belt buckles on the floor panel.
(4) Install the shoulder belt buckles. Install the lap
belt and buckle anchor bolts in the floor panel.
Tighten the anchor bolts to 40 N«m (350 in. lbs.)
torque.
• Bucket seats—Position the covers over the left and
right shoulder belt buckle anchor bolts.
(5) Connect the shoulder belt warning wire har­
ness connectors.
(6) If moved all the way forward for access, cor­
rectly position the front seat.
REAR SHOULDER BELTS/LAP
BELT/BUCKLES-RAMCHARGER
REMOVAL
(1) If necessary, move the front seat(s) all the way
forward for access.
Fig. 33 Ramcharger Bucket Seat Shoulder Belt
Buckles
SHOULDER ANCHOR LAP
BELT
BUCKLE . J9123-608
Fig. 34 Bench Seat Shoulder Belt Buckle & Lap
Belt/Buckle Anchors
(2) Remove the anchor bolts from the folding rear
seat frame (Fig. 36).
(3) Remove the buckles and the lap belt from the
folding seat frame.
(4) Remove the covers concealing the shoulder belt
upper anchor bolt.
(5) Remove the shoulder belt upper anchor bolts
from the roof inner liner.
(6) Remove the shoulder belt lower anchor bolts
from the floor panel.
(7) Remove the shoulder belt covers from the trim
panel.
(8) Remove the quarter panel lower trim panels. If
necessary, refer to the removal procedure.