Chrysler DODGE D150 1993 Service Manual page 1408

•
BODY COMPONENTS 23 - 2 i
(3) Raise the glass. Slide it rearward and engage
the channel with the regulator a r m roller.
(4) Install the vent window.
(5) Test the window glass and regulator operation.
Correct as necessary.
(6) Install the door waterdam and the trim panel.
Fig. 7 Power Window Glass Regulator
KEY LOCK CYLINDER
REMOVAL
(1) Raise the window glass to the closed position.
(2) Remove the door trim panel and the waterdam.
(3) Disconnect the lock cylinder latch rod at the
door latch.
(4) Remove the key lock cylinder retainer clip. Re­
move the lock cylinder from the door (Fig. 8).
INSTALLATION
(1) Install the lock cylinder in the door hole. Re­
tain the lock cylinder with the retainer clip.
(2) Connect the lock cylinder latch rod to the door
latch.
(3) Test (and adjust, if necessary) the door lock cyl­
inder latch rod operation.
(4) Install the door trim panel and the waterdam.
DETERMINING KEY/LOCK CODE
When the door key or the key code is not available,
the following procedure can be used to determine the
key code.
(1) Remove the lock cylinder from the door.
(2) Remove the tumbler cover from the lock cylin­
der housing and discard it (Fig. 9).
(3) Individually remove each spring, driver and
tumbler set from the lock cylinder housing.
DOOR KEY
Fig. 8 Key Lock Cylinder Removal/Installation
(4) Use t h e code plate to determine the code num­
ber for each set and record the results.
(5) Continue, as instructed above, to determine the
complete key/lock code with the remaining sets of
spring, driver and tumbler.
(6) Assemble the original tumbler, driver
and
spring sets (if not damaged) in the lock cylinder
housing.
(7) Install a replacement tumbler cover on the lock
cylinder housing.
(8) Install the key lock cylinder in the door. If nec­
essary, refer to the installation procedure.
Fig. 9 Key Lock Cylinder Components
DOOR LATCH STRIKER
REPLACEMENT
(1) Remove the striker and spacer from the B-pil-
lar (Fig. 10).