Chrysler DODGE D150 1993 Service Manual page 1321

21 - 320 TRANSMISSION 0¥ERHAUL-46RH
LEVER STRUT
J9121-18
Fig. 147 Front Band And Linkage Installation—46RH
Fig. 148 Installing Oil Pump Gasket And Pilot
Studs-46RH
(32) Lubricate oil pump seals with petroleum jelly
or transmission fluid.
(33) Mount oil pump on pilot studs and slide pump
into case opening (Fig. 150). Work p u m p into c a s e
b y hand. D o not u s e a mallet or similar tools to
seat p u m p .
(34) Remove pilot studs and install oil pump bolts.
Tighten pump bolts alternately and evenly to fully
seat pump in case. Then final-tighten pump bolts to
20 N-m (15 ft. lbs.) torque.
(35) Verify correct assembly. Rotate input and out­
put shafts and check for bind. If bind exists, compo­
nents are either misassembled, or not seated.
Disassemble and correct as necessary before proceed­
ing.
•
Fig. 149 Reaction Shaft Seal Ring And Thrust
Washer installation—46RH
Fig. 150 Oil Pump installation—46RH
(a) Attach dial indicator to converter housing
(Fig. 151). Position indicator plunger against input
shaft and zero indicator.
(b) Move input shaft in and out and record read­
ing.
(c) End play should be 0.86 - 2.13 mm (0.034 -
0.084 in.).
(36) Check input shaft end play as follows: