Chrysler DODGE D150 1993 Service Manual page 1419

23 - 36 BODY COMPONENTS
SCREW
INSTRUMENT
CLUSTER
(REAR)
SHIFT
INDICATOR
STEERING
COLUMN
J9123-539
Fig. 3 A/T Shift Position Indicator
INSTALLATION
(1) Position the shift position (PRNDL) indicator
on the instrument cluster.
(2) Install the indicator screws in the rear of the
instrument cluster. Tighten the screws to 2 N»m (17
in. lbs.) torque.
(3) Connect the indicator wire to the steering col­
umn.
ASH RECEIVER TRAY AND HOUSING
REMOVAL
(1) Disconnect the wire harness connector from the
cigarette lighter. Remove the ash receiver tray from
the housing.
(2) Remove the housing screws from t h e instru­
ment panel.
(3) Disconnect the wire harness connector from the
lamp. Remove the housing from the instrument
panel.
INSTALLATION
(1) Position the ash receiver tray housing at the
instrument panel. Connect the wire harness connec­
tor to the lamp.
(2) Install the housing screws in the instrument
panel. Tighten the screws to 2 N«m (17 in. lbs.)
torque.
(3) Position the ash receiver tray in the housing.
Connect the wire harness connector to the cigarette
lighter.
GLOVE BOX
REMOVAL
(1) Remove the glove box door hinge screws from
the instrument panel (Fig. 5).
(2) Remove the glove box from the instrument
panel.
INSTRUMENT
PANEL
SCREW
LAMP
HOOD
PANEL
ASH
TRAY
' HOUSING -
LIGHTER
ELEMENT
SCREW
LIGHTER
CLAMP
ASH
TRAY
HOUSING
LIGHTER
SHELL
ASH
RECEIVER
TRAY
J9123-346
Fig. 4 Ash Receiver Tray & Housing
INSTALLATION
(1) Position the glove box at the instrument panel.
(2) Install the door hinge screws. Tighten the
screws to 3 N»m (24 in. lbs.) torque.
INSTRUMENT
PANEL
STRIKER SCREW BUMPER
GLOVE
BOX
DOOR
LAMP
SWITCH
LAMP
LENSE
SCREW HINGE
NAME
PLATE
J9123-345
Fig. 5 Glove Box
LOCK CYLINDER AND LATCH REMOVAL
(1) Remove the glove box latch screws from the
door panel.
(2) Separate the latch from the lock cylinder.
(3) Remove the lock cylinder and the latch from
the door panel.
LOCK CYLINDER AND LATCH INSTALLATION
(1) Insert the lock cylinder in the door panel hole.
Engage it with the latch.
(2) Install the latch screws in the door panel.
Tighten the screws to 2 N»m (17 in. lbs.) torque.