Chrysler DODGE D150 1993 Service Manual page 1462

•
HEATING AND AIR CONDITIONING 24 - 25
J8924-28
Fig. 13 Check Air Gap
COMPRESSOR SHAFT SEAL
REMOWAL
(1) Insert the 2 pins of the front plate spanner into
any 2 threaded holes of the clutch front plate (Fig.
2). Hold clutch plate stationary. Remove hex nut.
(2) Remove clutch front plate using puller. Align
puller center bolt to compressor shaft. Thumb tighten
the 3 puller bolts into the threaded holes.
(3) Turn center bolt clockwise until front plate is
loosened.
Shaft seal replacement should be done on the
bench. N e v e r use any old parts of the shaft seal
assembly. Rebuild the complete assembly.
(4) Insert the snap ring tool points into the 2 holes
of the felt ring metal retainer and remove felt ring
(Fig. 14).
(5) Remove the clutch shim. Use O-ring hook and
a small screwdriver to prevent shim from binding on
shaft (Fig. 15).
(6) Remove shaft seal seat retaining snap ring
with pinch type snap ring pliers (Fig. 16).
J8924-31
Fig. 16 Snap Ring
Fig. 14 Felt Ring