Chrysler DODGE D150 1993 Service Manual page 960

PROPELLER SHAFTS
16 - 15
(10) Check for proper assembly. Flex t h e CV joint
beyond center, it should snap over-center in both di­
rections when correctly assembled (Fig. 20).
(11) Add grease to all three lube fittings.
(12) Install the propeller shaft. Refer to Propeller
Shaft Replacement in this group.
J9316-18
Fig. 20 Check Assembly
TORQUE SPECIFICATIONS
PROPELLER SHAFTS A N D U - J O I N T S
D E S C R I P T I O N
T O R Q U E
Center Bearing to Support
Bracket (Two Piece Shaft)
68 N-m (50 ft. lbs.)
Double Cardan to Transfer
Case Yoke Bolts
88 N-m (65 ft. lbs.)
Prop Shaft to Axle Yoke
Screws (Gas Engine) 19 N-m (14 ft. lbs.)
Prop Shaft to Axle Yoke
Screws (Diesel Engine) 29 N-m (21 ft. lbs.)
J9216-24