Chrysler DODGE D150 1993 Service Manual page 1433

23 - 50 BODY COMPONENTS — < ^ ^ • •
DOME LAMP DOME/READING LAMP
J9123-400
Fig. 45 Ramcharger Dome Lamp & Dome/Reading
Lamp
(2) Connect the bulb holder wire harness connec­
tors.
(3) Insert the lense bracket in the headliner hole.
Install the screws in the roof inner panel. Tighten
the screws to 4 N # m (35 in. lbs.) torque.
(4) Install the lamp lense on the bracket.
DOME LAMP-CLUB CAB
REMOVAL
(1) Remove the screws and t h e dome lamp lense
from the lamp housing (Fig. 44).
(2) Disconnect the bulb holder wire harness con­
nectors.
(3) Remove the screws and t h e bulb holder bracket
from the lamp housing.
(4) Remove the bulb holder and bracket from the
lamp housing.
INSTALLATION
(1) Position the bulb holder and bracket a t the
lamp housing.
(2) Install the bulb holder bracket screws in the
lamp housing. Tighten the screws to 4 N°m (35 in.
lbs.) torque.
(3) Connect the bulb holder wire harness connec­
tors.
(4) Position the lense on the lamp housing. Install
the screws. Tighten the screws to 4 N # m (35 in. lbs.)
torque.
SUNVISORS
REMOVAL
(1) Remove the screws t h a t attach the sunvisor
arm support bracket to the roof inner panel (Figs. 42
and 43).
(2) Detach the sunvisor from t h e clip.
(3) Remove the sunvisor from t h e roof inner panel.
(4) Remove the screw and the clip from the roof in­
ner panel.
INSTALLATION
(1) Install the sunvisor clip with the screw.
Tighten the screw to 4 N*m (35 in. lbs.) torque,
(2) Position the sunvisor in the clip. Align the a r m
support bracket holes with the headliner holes.
(3) Install the screws t h a t attach the sunvisor a r m
support bracket to the roof inner panel. Tighten the
screws to 4 N * m (35 in. lbs.) torque.
FLOOR CONSOLE AND REAR STORAGE TRAY
CONSOLE
REMOVAL
(1) Open the console lid (Fig. 46).
(2) Remove the console front and rear screws from
the floor panel.
(3) Remove the console from the floor.
INSTALLATION
(1) Position the console on the floor.
(2) Install the screws in the floor panel. Tighten
screws to 4 N«m (35 in. lbs.) torque.
(3) Close the console lid.
STORAGE TRAY-STANDARD
CAB
REMOVAL
(1) Remove the contents from the storage tray.
(2) Remove the screws from the floor panel and t h e
tray (Fig. 47).
(3) Remove the storage tray from the floor panel.
INSTALLATION
(1) Position the storage tray on the floor panel.
(2) Install the screws in the tray and floor panel.
Tighten the screws to 4 N«m (35 in. lbs.) torque.
Fig. 46 Floor Console