Chrysler DODGE D150 1993 Service Manual page 958

• PROPELLER SHAFTS 16 - 13
(2) Place a bearing assembly in a tube yoke hole
and over a trunnion. Keep the needle bearings up­
right in the bearing assembly (Fig. 12). A needle
roller lying at the bottom will prevent proper assem­
bly. Be sure to remove any lube fittings t h a t may in­
terfere with removal.
Fig. 12 Install Bearing Assembly
(3) Press the bearing assembly in place and install
a snap ring (Fig. 13).
Fig. 13 Press in Bearing Assembly
(4) Flip the tube yoke and bearing assembly instal­
lation on the opposite trunnion. Install a snap ring
(Fig. 14).
J 9 3 1 6 - 1 2
Fig. 14 Press In Bearing Assembly
(5) Fit the center yoke on the remaining two trun­
nions and press bearing assemblies in place, both
sides (Fig. 15). Install a snap ring.
J 9 3 1 6 - 1 3
Fig. 15 Install Center Yoke