Chrysler DODGE D150 1993 Service Manual page 1498

•
EMISSION CONTROL SYSTEMS
25 - 21
(4) Remove solenoid and its support bracket from
intake manifold (one bolt—5.2L/5.9L engine, one
nut—3.9L engine).
(5) Remove EVAP canister purge solenoid from en­
gine.
INSTALLATION
(1) Install EVAP canister purge solenoid and its
mounting bracket to intake manifold.
(2) Connect vacuum harness and wiring connector.
(3) Install air filter housing.
FUEL TANK FILLER TUBE CAP
If replacement of the fuel filler tube cap (Fig. 11) is
necessary, it must be replaced with an identical cap
to be sure of correct system operation.
C A U T I O N : Remove the fuel tank filler tube cap to
relieve fuel tank pressure. The cap must be re­
moved prior to disconnecting any fuel system com­
ponent or before draining the fuel tank.
PLASTIC
GASKET
RN348
Fig. 11 Fuel Tank Filler Tube Cap—Typical
OXYGEN (0
2
) SENSOR
For description, operation, diagnosis and removal/
installation procedures of the 0
2
sensor, refer to
Group 14, Fuel Systems.
POWERTRAIN CONTROL MODULE (PCM)
For removal and installation procedures, refer to
Group 14, Fuel Systems.
PRESSURE RELIEF/ROLLOWER W A L W E
For removal and installation procedures, refer to
the Fuel Tank section of Group 14, Fuel Systems.