Chrysler DODGE D150 1993 Service Manual page 715

9 - 119 5.9L (DIESEL) ENGINE
Fig. 10 intercooler Ducts
(10) Remove the drive belt. Disconnect the genera­
tor ground wire. Remove the generator and set aside
(Fig.
11).
(11) Remove the A/0 compressor and set aside. The
A/C compressor is located below the generator.
(12) Disconnect the accelerator linkage, the speed
control linkage and the throttle valve linkage (Fig.
12).
(13) Raise and support the vehicle on a hoist.
(14) Drain the engine lubricating oil. Dispose of
the oil according to all applicable regulations.
(15) Disconnect the exhaust pipe steady rest clamp
and remove.
(16) Disconnect the starter connections (Fig. 13).
(17) Disconnect the transmission cooler lines.
(18) AUTOMATIC TRANSMISSION:
(a) Remove torque converter bolt access cover.
•
Fig, 11 Generator Removal
Fig. 12 Accelerator/Speed Control/Throttle Valve
Linkage
(b) M a r k torque converter and drive plate for as­
sembly alignment. Note t h a t bolt holes in crank­
shaft flange, drive plate and torque converter all
have one offset hole.
(c) Rotate crankshaft in clockwise direction until
converter bolts are accessible. Then remove bolts
one at a time. Rotate crankshaft with socket
wrench on damper pulley bolt.
(d) Support the transmission.
(e) Remove bell housing bolts and inspection
plate.
(19) M A N U A L TRANSMISSION:
Refer to Group 21, Transmissions for the G360
Manual Transmission Removal procedure.
(20) Lower the vehicle.
(21) Disconnect the power steering lines.