Chrysler DODGE D150 1993 Service Manual page 713

9 - 108 §.9L (DIESEL) ENGINE
•
J9109-12
Fig. 3 Engine Front Mount
INSTALLATION
(1) Install the engine mounting brackets to the
block, if removed (Fig. 3). Tighten the bolts to 60
N-m (44 ft. lbs.) torque.
(2) With the engine raised slightly, install the in­
sulators using the locating pin. Tighten the n u t s to
109 N-m (80 ft. lbs.) torque.
(3) Install the bracket onto the insulator and
tighten the n u t to 109 Nnn (80 ft. lbs.) torque.
(4) Lower engine with lifting fixture while guiding
insulator studs into attaching holes in crossmember
and brackets.
(5) Tighten attaching nuts and bolts to specified
torques (Fig. 3).
(6) Lower the vehicle.
(7) Remove lifting fixture.
ENGINE REAR SUPPORT
REMOVAL-2WD
(1) Raise the vehicle on a hoist.
(2) Position a transmission jack under the trans­
mission.
(3) Remove the through-bolt from the transmission
support bracket/insulator (Fig. 4).
(4) Raise the transmission SLIGHTLY.
(5) Remove the insulator nuts (Fig. 4).
(6) Remove the transmission blocker bracket n u t s
and remove the bracket (Fig. 4).
(7) Remove the insulator/crossmember bracket
nuts and remove the bracket (Fig. 4).
INSULATOR
TRANSMISSION
BLOCKER
BRACKET
TRANSMISSION
SUPPORT
BRACKET
INSULATOR/
CROSSMEMBER
BRACKET
CROSSMEMBER
J9109-149
Fig. 4 Rear Engine Support—2WD
INSTALLA TION-2WD
(1) Install the insulator/crossmember bracket to
the crossmember. Tighten the nuts to 41 N-m (30 ft.
lbs.) torque.
(2) Install the transmission blocker bracket to the
crossmember and the insulator/crossmember bracket
(Fig. 4). Tighten the nuts to 41 N-m (30 ft. lbs.)
torque.
(3) Install the insulator to the crossmember and
the insulator/crossmember bracket (Fig. 4). Tighten
the nuts to 41 N-m (30 ft. lbs.) torque.
(4) Lower the transmission until the insulator is
lined up with the transmission support bracket.
(5) Install the through-bolt and tighten the n u t to
68 N-m (50 ft. lbs.) torque.
(6) Remove the transmission jack.
(7) Lower the vehicle.
REMOVAL-4WD
(1) Raise the vehicle on a hoist.
(2) Remove the skid plate (if equipped) from the
rear crossmember and transmission crossmember
(Fig. 5).
SKID PLATE ^ M A T T A C H I N G BOLTSl
. M I M I N G
PU873
Fig. 5 Skid Plate
(3) Position a transmission jack under the trans­
mission.
(4) Remove the nuts from the transfer case to plate
bolts and from the transfer case to strut bolts (Fig.
6).