Chrysler DODGE D150 1993 Service Manual page 1226

•
TRANSMISSION OVERHAUL—36RH/37RH 21 - 225
(4) Compress rear servo piston with C-clamp or
Valve Spring Compressor C-3422-B and install servo
piston snap ring (Fig. 105).
Fig. 105 Installing Rear Servo Snap Ring—36RH/
37RH
(5) Install overrunning clutch cam, springs, rollers,
race and rear support if not yet installed. Refer to in­
stallation procedure in Subassembly Overhaul sec­
tion.
(6) Position rear band and link in case (Fig. 106).
Be s u r e n o t c h e d side of l i n k f a c e s a w a y from
b a n d .
Fig. 106 Installing Rear Band And Link—36RH/37RH
(7) Install low-reverse drum (Fig. 107). Slide drum
through rear band, onto rear support hub and into
engagement with overrunning clutch race.
Fig. 107 Installing Low-Reverse Drum—36RH/37RH
(8) Install snap ring t h a t secures low-reverse drum
to rear support hub (Fig. 108).
Fig. 108 Installing Low-Reverse Drum Snap
Ring—36RH/37RH
(9) Install new O-rings on band reaction pin. Lu­
bricate pin and O-rings. Then insert pin into case
and part way into band link (Fig. 109).
(10) Install rear band adjusting lever, strut and re­
action lever (Fig. 110). Be sure levers and strut are
aligned and engaged before seating band reaction pin
in case.