Chrysler DODGE D150 1993 Service Manual page 804

•
FRAME AND BUMPERS 13 - 17
Fig. 15 Snow Plow Frame Removal/Installation
(3) Remove the nuts, washers and bolts t h a t attach
the pivot bracket to the vehicle frame side rails (Fig.
16).
(4) Remove the pivot bracket from the vehicle
frame rails (Fig. 16).
INSTALLATION
(1) Position and support the pivot bracket at the
vehicle frame rails with t h e bolt holes aligned (Fig.
16).
(2) Install the pivot bracket attaching bolts, wash­
ers and nuts finger-tight (Fig. 16).
(3) Install the support strap attaching bolts and
nuts (Fig. 15). Tighten the n u t s to 68 N*m (50 ft.
lbs.) torque.
(4) Tighten the pivot bracket attaching nuts to 68
Nrni (50 ft. lbs.) torque.
(5) Remove the support from under the pivot
bracket.
SNOW PLOW CONTROL MODULE
FRAME FRAME
REMO VAUDISASSEMBL Y
(1) Remove the screws and module retainers from
the instrument panel (Fig. 17).
(2) Remove the control module from the instru­
ment panel (Fig. 17).
(3) Remove the module housing attaching screws
(Fig. 18).
(4) Separate the switch cover from the housing
(Fig. 18).
J9101-1
Fig. 16 Snow Plow Pivot Bracket
Removal/Installation
(5) Detach the lamp holders from the switch cover.
Disconnect the wire harness connectors from the
switches (Fig. 18).