Chrysler DODGE D150 1993 Service Manual page 1189

21 - 188 TRANSMISSION OVERHAUL—32RH
•
Fig. 124 Installing Governor Body Snap Ring—32RH
Fig. 125 Installing Output Shaft Thrust PIate-32RH
Fig. 126 input Shaft Seal Ring Location-32RH
(31) Align clutch discs in front clutch and install
front clutch on rear clutch (Fig. 127). Rotate front
clutch retainer back and forth until completely
seated on rear clutch.
Fig. 127 Assembling Front And Rear Clutch
Units-32RH
(32) Coat output shaft thrust washer with petro­
leum jelly. Then install washer in rear clutch hub
(Fig. 128). Use enough petroleum jelly to hold
washer in place. Be sure grooved side of w a s h e r
faces rearward (toward output shaft) as s h o w n .
Also note that w a s h e r only fits one w a y in
clutch hub.
Fig. 128 Installing Output Shaft Thrust
Washer-32RH
(33) Align drive teeth on rear clutch discs with
small screwdriver (Fig. 129). This will make installa­
tion on front planetary easier.
(34) Raise front end of transmission upward as far
as possible and support case with wood blocks. Front/
rear clutch and oil pump assemblies are easier to in­
stall if transmission is as close to upright position as
possible.
(35) Install front and rear clutch units as assembly
(Fig. 130). Align rear clutch with front annulus gear
and install assembly in driving shell. Be sure out­
put shaft thrust w a s h e r and thrust plate are not
displaced during installation.