Chrysler DODGE D150 1993 Service Manual page 1407

23 - 24 BODY COMPONENTS
•
(4) Use the door inner panel opening for access.
Position run channel into the lower part of door side
channel guide while lowering the window glass.
(5) Test the window glass operation and correct as
necessary.
(6) Install the door waterdam and the trim panel.
WINDOW GLASS
REMOVAL
Remove door trim panel and the waterdam.
(2) Remove the beltline weatherstrip seals (Fig. 5 ) .
(3) Lower the glass to the full open position. Re­
move the vent window.
(4) Slide the glass forward until the channel sepa­
rates from the window regulator arm roller.
(5) Remove the glass and channel from the door.
INSTALLATION
(1) Lubricate the glass channel.
(2) Position the glass and channel in the door.
(3) Slide the glafes rearward and engage the chan­
nel with the regulator arm roller.
(4) Install the vent window. If necessary, refer to
the installation procedure. Raise the glass to the full
closed position.
(5) Install the beltline weatherstrip seals.
(6) Install the door waterdam and the trim panel.
WEATHERSTRIP
GLASS
D O O R
INNER
PANEL
D O O R
OUTER
PANEL
REGULATOR
(MANUAL)
J9123-398
Fig. 5 Window Glass, Regulator, Weatherstrip Seals
& Channel
MANUAL WINDOW GLASS REGULATOR
REMOVAL
(1) Remove the door trim panel and the waterdam.
(2) Lower the glass to the full open position. Re­
move the vent window.
(3) Slide the glass forward until the channel sepa­
rates from the window regulator arm roller.
(4) Lower the glass and channel to the bottom of
the door.
(5) Remove the center of the regulator rivets with
a drift punch (Fig. 6). Drill them out with a 6 mm
(1/4-in) diameter drill bit.
(6) Remove the regulator from the door.
INSTALLATION
(1) Position the regulator in the door (Fig. 6). Re­
tain it on the inner door panel with 1/4-20 x 1/2 bolts
and nuts. Tighten the nuts to 10 N*m (90 in. lbs.)
torque.
(2) Raise the glass. Slide it rearward and engage
the channel with the regulator arm roller.
(3) Install the vent window.
(4) Test the window glass and regulator operation.
Correct as necessary.
(5) Install the door waterdam and the trim panel.
D O O R OUTER
PANEL
GUIDE D O O R
INNER
PANEL
REAR FRONT
RIVET RIVET
HOLES HOLES
RIVET
MANUAL
REGULATOR
J9123-395
Fig. 6 Manual Window Glass Regulator
POWER WINDOW GLASS REGULATOR
REMOVAL
(1) Remove the trim panel and the waterdam.
(2) Open the window glass.
(3) Remove the vent window.
(4) Slide the glass forward until the channel sepa­
rates from the window regulator arm roller.
(5) Lower the glass and channel to the bottom of
the door.
(6) Remove the center of the regulator rivets (Fig.
7) with a drift punch. Drill them out with a 6 mm
(1/4-in) diameter drill bit.
(7) Disconnect the regulator motor wire harness
connector.
(8) Remove the power regulator from the door.
INSTALLATION
(1) Position the power regulator in the door. Re­
tain it on the inner door panel with 1/4-20 x 1/2 bolts
and nuts. Tighten the nuts to 10 Nnn (90 in. lbs.)
torque.
(2) Connect the regulator motor wire harness con­
nector.