Chrysler DODGE D150 1993 Service Manual page 1250

• TRANSMISSION OVERHAUL-42RH 21 - 24S
J9121-538
Fig. 63 Installing Rear Clutch Retainer And Input
Shaft Seal Rings—42RH
J912M51
Fig. 64 input Shaft Seal Ring Identification—42RH
(3) Lubricate splined end of input shaft and clutch
retainer with transmission fluid. Then press input
shaft into retainer (Fig. 65).
(4) Install input shaft retaining ring (Fig. 61).
(5) Install new seals on clutch piston. Be sure lip
of e a c h seal faces interior of clutch retainer.
(6) Lubricate lip of piston seals with liberal quan­
tity of Door Eze, or petroleum jelly. Then lubricate
retainer hub and bore with transmission fluid.
Fig. 65 Pressing Input Shaft Into Rear Clutch
Retainer—42RH
(7) Install clutch piston in retainer. Use twisting
motion to seat piston in bottom of retainer. D o not
attempt to p u s h the piston straight in. This
could fold the seals over causing l e a k a g e and
clutch slip.
(8) Install piston spring in retainer and on top of
piston (Fig. 56). Concave side of spring faces up as
shown.
(9) Install wave spring in retainer (Fig. 66). Be
sure spring is completely seated in retainer groove.
Fig. 66 Piston And Wave Spring Position—42RH
(10) Install bottom pressure plate (Fig. 60). Ridged
side of plate faces downward (toward piston) and flat
side toward clutch pack.