Chrysler DODGE D150 1993 Service Manual page 1393

2 3 - 1 0 BODY COMPONENTS
(5) Press the moulding onto the panel with a roller
(or use hand pressure) to ensure complete adhesion.
QUARTER PANEL
MOLDING
FRONT
FENDER
REAR
MOLDING
FRONT
FENDER
FRONT
MOLDING
REAR
CARGO DOOR
FRONT
^ W H E E W O U S E
~SST
M S S N G
W ^|S $ E
SIDE OPENING SIDE
PANEL MOLDING PANEL
REAR MOLDING
MOLDING
QUARTER
PANEL
MOLDING
OPENING
MOLDING
ADHESIVE-BACKED
MOLDING
NUT
QUARTER
PANEL
MOLDING
EXTENDED CAB
STANDARD CAB
10.5 MMlyx
CHARACTER \
UNE
J9123-603
Fig. 25 Ram Truck Body Side Mouldings
REMOVAL—WHEEL LIP MOULDINGS
(1) Remove the screws from the moulding (Fig. 25).
(2) Soften the wheel lip moulding tape adhesive
with a heat gun.
(3) Peel the moulding and tape from the wheel-
house. Apply additional heat to any location where
the moulding adhesive remains.
INSTALLATION—WHEEL LIP MOULDINGS
(1) Remove the backing from the double sided
tape.
(2) Align the moulding with the screws holes in
the fender panel. Install the screws into the fender
panel. Tighten the screws to 3 N*m (24 in. lbs.)
torque.
(3) Press the moulding onto the wheelhouse with a
roller (or use hand pressure).
NAMEPLATES
REMOVAL
(1) Soften the nameplate/badge tape adhesive
(Figs. 26 and 27) with a heat gun.
(2) Lift one edge of the nameplate with a putty
knife (or a similar thin-blade tool). Peel the mould­
ing and tape from the panel. Apply additional heat to
any location where the tape remains.
(3) Remove the residual tape adhesive from the
panel with 3M All Purpose Cleaner or an equivalent.
INSTALLATION
(1) Clean the painted panel surface with a com­
mercial wax and silicone removal solution. Wipe the
surface with a clean cloth and allow it to dry.
(2) Use masking tape to indicate the upper posi­
tion for the nameplate on the panel (Figs. 26 and 27).
(3) Remove the backing from the nameplate. Align
the nameplate with the alignment reference tape. Po­
sition the nameplate on the panel.
(4) Verify t h a t the nameplate is properly aligned.
Remove the alignment reference tape.
(5) Press the nameplate onto the panel with a
roller (or use hand pressure).
DOOR
OPENING
B-PILLAR
NAMEPLATE
J9123-356
Fig. 26 Ram Truck Nameplates
SIDE
WINDOW
B-PILLAR
NAMEPLATE
DOOR OPENING
FRONT
FENDER
NAMEPLATE
J9123-357
Fig. 27 Ramcharger Nameplates
TAILGATE AND CARGO BOM DECALS
The raised letters on the tailgate are covered with
a durable, weather-resistant decal. The cargo box
side panel decal also is a durable, weather-resistant
decal.
REMOVAL
(1) Soften the decal adhesive with a heat gun.
(2) Lift one edge of the decal with a putty knife.
Slowly peel the decal from the panel.