Chrysler DODGE D150 1993 Service Manual page 1227

TRANSMISSION OVERHAUL—36RH/37RH

Fig. 109 Installing Rear Band Reaction Pin—36RH/

Fig. 110 Rear Band Levers And Strut—36RH/37RH

(11) Lubricate front servo piston components and

servo bore in case with transmission fluid.

(12) Install front servo piston in bore. Carefully

"run" small, suitable tool around piston ring to press

it back into groove and ease installation (Fig. 111).

Rotate piston into bore at same time. Rock piston

slightly to ease piston ring past snap ring groove and

(13) Bottom front servo piston in bore and install

servo spring.

(14) Install front servo piston rod guide as follows:

(a) Place Tool SP-5560 (or similar size tool) on

guide to serve as press tool for C-clamp.

(b) Position C-clamp on press tool and case (Fig.

USE SUITABLE TOOL

TO HELP SEAT

Fig. 111 Installing Front Servo Piston—36RH/37RH

neously easing seal ring into bore with suitable

tool (tighten clamp screw with one hand and "run"

tool around guide ring with other hand).

(15) Install rod guide snap ring (Fig. 112).

Fig. 112 Installing Front Servo Rod Guide And Snap

Ring—36RH/37RH

(16) Position front band lever in case and over

servo rod guide. Then install front band reaction pin

in case and slide it through lever.

(17) Coat threads of front band reaction pin access

plug with sealer and install it in case. Tighten plug

to 17 Nnn (13 ft. lbs.) torque.

(18) Install assembled output shaft and planetary

gear components (Fig. 113). S u p p o r t shaft c a r e -

Show Quick Links