Chrysler DODGE D150 1993 Service Manual page 1273

21 - 272 TRANSMISSION OVERHAUL-42RH
Fig. 139 Installing/Aligning Case Gasket—42RH
Fig. 140 installing Overdrive Piston Retainer—42RH
(17) Install planetary geartrain assembly (Fig.
143)
(18) Install thrust plate on intermediate shaft hub
(Fig. 144). Use petroleum jelly to hold thrust plate in
place.
(19) Check seal ring on rear clutch retainer hub
(Fig. 49) and seal rings on input shaft (Fig. 145).
Verify t h a t diagonal-cut ends of teflon seal rings are
properly joined and ends of metal ring are correctly
Fig. 141 Installing Low-Reverse Drum Retaining
Snap Ring
Fig. 142 Rear Band Lever And Pivot Pin Installation
hooked together. Also verify t h a t shaft seal rings are
installed in sequence shown.
(20) Check rear clutch fiber thrust washer (Fig.
146). Use additional petroleum jelly to hold washer
in place if necessary.
(21) Align clutch discs in front clutch and install
front clutch on rear clutch (Fig. 147). Rotate front
clutch retainer back and forth until completely
seated on rear clutch.
(22) Coat intermediate shaft thrust washer with
petroleum jelly. Then install washer in rear clutch
hub (Fig. 148). Use enough petroleum jelly to hold
washer in place. B e sure grooved side of w a s h e r
faces rearward (toward output shaft) as s h o w n .
Also note t h a t w a s h e r only fits one w a y in
c l u t c h h u b .