Chrysler DODGE D150 1993 Service Manual page 1415

23 - 32 BODY COMPONENTS
•
Fig. 9 Window installation Cord—Typical
INSTALLATION
(1) Position the sliding vent glass in the frame
track.
(2) Tighten all the screws at the bottom of the
frame,
(3) Test for correct travel. Check the latch opera­
tion for the sliding vent glass.
(4) Install rear window in the cab opening. If nec­
essary, refer to the installation procedure.
(5) Verify t h a t the drain holes are not restricted.
HATCHGATE WINDOW GLASS-RAMCHARGER
REMOVAL
(1) Use a trim stick to separate the glass seal lip
from the hatchgate flanges. Push the window glass
and seal outward from the top.
(2) Remove the seal and glass from the hatchgate.
(3) Remove the retainer strip from the weather­
strip seal.
(4) Remove the seal from the window glass.
(5) Clean the seal channels and window opening
flanges.
INSTALLATION
(1) Install the seal on the window glass.
(2) Apply mineral spirits to the retainer strip
channel in the weatherstrip seal.
(3) Install the retainer strip in the seal channel.
(4) Install the hatchgate window glass according to
the following instructions:
• Moisten a length of 6-mm (1/4-in) diameter cord
with a soap and water solution;
• Verify t h a t the cord is long enough to go all the
way around the edge of the weatherstrip seal
• Insert the cord into the window flange in the seal
• Position the glass in the window opening with the
free ends of the cord inside the vehicle
• Pull on the cords to pull the seal channel lip over
the window flange
(5) After installation, release any curls from the
seal outer lip.
(6) Test the hatchgate window for water leaks.
(7) Clean the glass.
HATCHGATE RETAINER WEATHERSTRIP
Fig. 10 Hatchgate Window Glass & Seal
QUARTER WINDOW GLASS
REMOVAL
(1) Remove the quarter window glass interior trim
panel (Fig. 11).
Fig. 11 Quarter Window Interior Trim Panel
(2) Remove the quarter window exterior mouldings
(Fig. 12).
(3) Use an electric knife (Tool 4386 or an equiva­
lent) to cut the butyl tape.
(4) Remove the glass from the opening by applying
even pressure to the inside of the glass.