Chrysler DODGE D150 1993 Service Manual page 1430

BODY COMPONENTS

MODELS 30 & 60

Fig. 35 Shoulder Belt, Anchor Bolts & Retractor

(9) Remove the belt retractor support bracket an

chor bolts from the quarter panels.

(10) Remove the shoulder belts and the retractors

from the vehicle.

INSTALLATION

(1) Position the shoulder belt retractor support

brackets at the quarters above the wheelhouse. In

stall the support bracket anchor bolts in the quarter

panels. Tighten the anchor bolts to 40 Nnn (350 in.

lbs.) torque.

(2) Position the other end of the shoulder belt at

the floor panel. Install the lower anchor bolt in the

floor panel. Tighten the anchor bolts to 40 Nnn (350

in. lbs.) torque.

(3) Position the shoulder belt upper anchor plate at

the roof inner liner. Install the upper anchor bolts in

the roof inner liner. Tighten the anchor bolts to 40

Nnn (350 in. lbs.) torque.

(4) Position the covers over the upper anchor bolts.

(5) Install the quarter panel lower trim panel. If

necessary, refer to the installation procedure.

(6) Install the shoulder belt cover on the trim

panel. Tighten the screws to 1 Nnn (12 in. lbs.)

(7) Position the buckles and the lap belt on the

folding seat frame.

(8) Install the anchor bolts in the seat frame.

Tighten the bolts to 40 N-m (350 in. lbs.) torque.

(9) If applicable, adjust the front seat position.

Fig. 36 Rear Folding Seat Shoulder Belt Buckle &

Lap Belt/Buckle Anchors

S H O U L D E R ^

Fig. 37 Rear Seat Shoulder Belt—Ramcharger

Show Quick Links