Chrysler DODGE D150 1993 Service Manual page 1434

•
Fig. 47 Standard Cab Storage Tray
CARPETS AND FLOOR HATS
To remove a carpet/mat, all of the adjacent trim
panels must be removed. Also interfering components
should be removed as well as:
• Seat(s)
• Scuff plates
• Transmission and transfer case floor shift levers,
bezels and boots.
• Floor console
REMOWAL
(1) Remove the protective floor mats (if equipped).
(2) Remove all the interfering components.
(3) Remove the trim panels, retainers, sill-well
covers and scuff plates.
(4) Remove the carpet/mat from the floor panel
and the vehicle.
INSTALLATION
(1) Position the carpet/mat on the floor panel.
(2) Install seat(s) and all other necessary compo­
nents. If necessary, refer to the applicable installa­
tion procedure(s).
(3) Install the trim panels, retainers, sill-well cov­
ers and scuff plates.
(4) Place the floor mats (if equipped) on the carpet/
mat.
BODY COMPONENTS 23 - 51
Fig. 48 Carpet Or Mat—Standard Cab
CAB
Fig. 49 Rear Floor Noise Insulator & Sill-Well
Cover—Standard Cab
CLUB RETAINER
Fig. 50 Carpet, Scuff Plate, Sill-Well Cover & Rear
Retainer— Club Cab
CAB