Chrysler DODGE D150 1993 Service Manual page 1428

• BODY COMPONENTS 23 - 45
LOWER
SIDE TRIM
PANEL
Q U A R T E R
WINDOW
T R I M
PANEL
R O O F
I N N E R
PANEL
\ C S C R E W
QUARTER
PANEL
S C R E W
QUARTER W I N D O W QUARTER W I N D O W
TRIM
PANEL TRIM
PANEL
LOWER S E C T I O N UPPER SECTION
S C R E W
A S H
RECEIVER
BEZEL
A S H RECEIVER
LOWER SIDE
TRIM PANEL
CLIP
RETAINER
LOWER
SIDE TRIM
PANEL
R O O F
INNER
PANEL
RETAINER
RAIL
LOWER SIDE
TRIM PANEL
AT FLOOR PANEL
S C R E W REAR
HEADER
TRIM
PANEL
ABOVE HATCHGATE
J 9 1 2 3 - 3 9 2
Fig. 31 Quarter Panel & Hatchgate Header Trim
Panels—Removal/Installation
QUARTER PANEL LOWER TRIM PANELS
R E M O V A L
(1) For convenience, fold forward the rear passen­
ger seat.
(2) Remove the spare tire.
(3) Remove the rear pillar panel screws from the
hatchgate pillar inner panel (Fig. 30).
(4) Pry the trim panel end retainers from the quar­
ter inner panel slots.
(5) Disengage the lower trim panel clip retainers
from the wheelhouse.
(6) Remove the lower trim panel from the vehicle.
INSTALLATION
(1) Position the lower trim panel in the vehicle at
the quarter.
(2) Engage the trim panel clip retainers with the
wheelhouse rail retainers.
(3) Engage the trim panel end retainers with the
quarter inner panel slots.
(4) Position the rear pillar panel at the hatchgate
pillar panel. Install the screws and tighten to 1 N»m
(12 in. lbs.) torque.
(5) Install the spare tire.
SPARE TIRE CARRIER
RETAINER ROD AND STAND-OFF
(2) Remove the quarter window trim panel and the
quarter panel lower trim panels. If necessary, refer
to the removal procedures.
(3) Remove the rod retainer from the quarter panel
support bracket.
(4) Remove the tire stand-off cap, nut, bolt and
spacer from the quarter window lower panel.
INSTALLATION
(1) Install the tire stand-off bolt, spacer, nut and
cap. Tighten the nut to 41 N»m (30 ft. lbs.) torque.
(2) Install the rod retainer in the quarter panel
support bracket hole.
(3) Install the quarter window trim panel and the
quarter panel lower trim panels. If necessary, refer
to the installation procedures.
(4) Install the spare tire.
QUARTER
W I N D O W
TRIM PANEL
SPACER
BOLT
SIDE
INNER
' PANEL
SIDE
INNER
PANEL
STAND-OFF
CAP
TIRE STAND-OFF
NUT A N D INSERT
J 9 1 2 3 - 4 0 9
Fig. 32 Spare Tire/Wheel
SHOULDER BELTS/LAP BELT/BUCKLES
W A R N I N G : W H E N I N S T A L L I N G S H O U L D E R B E L T ,
L A P B E L T A N D B U C K L E A N C H O R B O L T S , V E R I F Y
THAT T H E Y A R E T I G H T E N E D T O 40 N-M (350 I N .
LBS.) T O R Q U E .
INSPECTION
Inspect the condition of all the belts and buckles
(Figs. 33, 34 and 35). Replace any belt or buckle that
is damaged in any way. Also, replace the shoulder
belt if the retractor is inoperative.
FRONT SHOULDER BELTS/LAP
BELT/BUCKLES
R E M O V A L
(1) If necessary, move the front seat(s) all the way
forward for access.
(2) Disconnect the shoulder belt warning wire har­
ness connectors.
R E M O V A L
(1) Remove the spare tire (Fig. 32).