KEB COMBIVERT F5 BASIC Applications Manual page 157

Set Value and Ramp Adjustment
Rotation adjustment via terminal
Input selection
Rotation direction F (Run/Stop) oP.60
Rotation direction R (forward/
reverse) oP.61
oP.1 = „2" or „3"
oP.1 = „4" or „5"
© KEB Antriebstechnik, 2002
All rights reserved
The rotation selection via terminal strip allows the adjustment of the direction of
strip rotation via switch or from a primary control.
With parameter oP.60 one input is determined for rotation direction forward (or run/
stop) and with oP.61 one input for rotation direction reverse (or forward/reverse).
Bit -No. Decimal value Input
0 1
1 2
2 4
3 8
4 16
5 32
6 64
7 128
8 256
9 512
10 1024
11 2048
1) default at oP.60
In the case of rotation selection forward/reverse (oP .1= „2" or „3") the inputs determined
with oP.60 and oP.61 work as follows:
Forward Revers
F R
0 0
0 1
1 0
1 1
In the case of rotation selection run/stop and forward/reverse (oP.1= „4" or „5") the
inputs determined with oP.60 and oP.61 work as follows:
Revers Forward
F/R Run/Stop Function
0 0
0 1
1 0
1 1
Name: Basis
KEB COMBIVERT F5-G / B
Functional Description
ST (Prog. input „Control release/Reset")
RST (Prog. input „Reset")
F (Prog. input „Forward")
R (Prog. input „Reverse")
I1 (Prog. input 1)
I2 (Prog. input 2)
I3 (Prog. input 3)
I4 (Prog. input 4)
IA (Internal input A)
IB (Internal input B)
IC (Internal input C)
ID (Internal input D)
2) default at oP.61
Input
X2A.14 X2A.15
Function
LS
Reverse
F
Forward
Forward
X2A.14 X2A.15
Input
LS
Run/Stop
Forward
LS
Reverse
Date
06.02.02
Terminal
X2A.16
X2A.17
1)
X2A.14
2) X2A.15
X2A.10
X2A.11
X2A.12
X2A.13
none
none
none
none
R
F/R
Chapter Section Page
6 4 7
6