KEB COMBIVERT F5 BASIC Applications Manual page 111

1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Annex
© KEB Antriebstechnik, 2002
All rights reserved
6.1 Operating and Applicance
Date
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Set Value and Ramp
Adjustment
6.5 Voltage-/Frequency
Characteristic (U/f)
Adjustment
6.6 Motor Data Adjustment
6.7 Protective Functions
6.8 Parameter Sets
6.9 Special Functions
6.10 Encoder Interface
6.11 SMM, Posi, Synchron
6.12 Technology Control
6.13 CP-Parameter Definition
Name: Basis
KEB COMBIVERT F5
Functional Description
6.2.1 Summary Description
Analog Inputs ......................... 3
6.2.2 Interface Selection .................. 4
6.2.3 Interference Suppression Filter 5
6.2.4 Save mode ............................. 5
6.2.5 Input selection ........................ 5
6.2.6 Zero point hysteresis .............. 6
6.2.7 Amplifier of the Input
Characteristic ......................... 7
6.2.8 Lower and Upper Limit ............ 8
6.2.9 Selection Set Point-/
Auxiliary Input ........................ 9
6.2.10 Summary Description
Analog Outputs ..................... 10
6.2.11 Output Signals ...................... 11
6.2.12 Analog Output / Functions .... 11
6.2.13 Analog Output / Display ........ 11
6.2.14 Amplifier of the Output
Characteristic ....................... 11
6.2.15 Period ANOUT3 .................... 13
6.2.16 Digital Settings ..................... 13
6.2.17 Used Parameters .................. 14
Date
12.04.02
Chapter Section Page
6 2 1