KEB COMBIVERT F5 BASIC Applications Manual page 39

Fundamentals
4. Operation
4.1 Fundamentals
4.1.1 Parameters,
Parameter Groups,
Parameter Sets
Example:
© KEB Antriebstechnik, 2002
All Rights reserved
The following chapter describes the fundumentals of the software structure as well
as the operation of the unit.
The control boards F5-BASIC anf F5-GENERAL incorporates 3 operating modes:
Customer Mode
- is a list of parameters
(CP-Parameter), freely
definable, which are
necessary or important
for the user.
- suppllied with a para-
meter list defined by
KEB
What are parameters, parameter groups and parameter sets?
Parameters are values changeable by the operator in a program, which have an
influence on the program flow. A parameter consists of
Parameter designation
To maintain a cleary-to-survey operation inspite of the great
number of parameters, we have combined function-related
parameters into parameter groups (e.g. all motor-related
parameters are combined in the Drive(dr)-group).
8 parameter sets (0...7) exist to adjust several values for one
parameter. If the active values shall be displayed for a running unit
the digit is set to „A". The digit is not-applicable for non-
programmable parameters (see chapter 6.8).
A conveyor belt shall be used with 3 different speeds. A parameter set is programmed
for each „speed" ... acceleration, deceleration etc. can be adjusted individually.
Name: Basis
KEB COMBIVERT F5
Operation
Operating Modes of
Control Board
Application Mode
- all parameter groups
(exception: CP-
parameter) and
parameter sets can be
selected and,
necessary, changed
- usually it is activated
only for the adaption to
the application
and
The parameter value shows the
actual setting.
The parameter number specifies the parameters
within a group.
Date
10.04.02
Drive Mode
- with this special mode,
the unit can be put into
operation via operator
- with the exception of the
control release no termi-
nal wiring is needed
if
Parameter value
Chapter Section Page
4
1 3
4