Initial Start-up
7.2.4
Testing of Drive
Picture 7.2.4
Testing of drive
Put the drive in all possible operating
©
KEB Antriebstechnik, 2002
All Rights reserved
For the drive to always allow a save controlling through the inverter, carry out the
following test under the most adverse operating conditions.
Testing of drive
Switch release and adjust
direction of rotation
Adjust low set value
Does the drive run with the
selected direction of rotation?
conditions of the application
Was an error triggered?
Test OK!
Name: Basis
KEB COMBIVERT F5-G / B
Start-up
check phase sequence of
no
motor cable, if necessary,
change
No
yes
see Error Assistance
Chapter 9
Yes
Date
Chapter
7
01.02.02
7
Section
Page
2
5
Need help?
Do you have a question about the COMBIVERT F5 BASIC and is the answer not in the manual?