KEB COMBIVERT F5 BASIC Applications Manual page 100

Functional Description
ru.33 Analog output 1 / display before amplification
Adr.
0221h
This parameter shows the value of the analog signal ANOUT1 in percent before passing the characteristic amplifier
(also see Chapt. 6.2. „Analog outputs").
ru.34 Analog output 1 / display after amplification
Adr.
0222h
This parameter shows the value of the signal given out on analog output ANOUT1 (terminal X2A.5) in percent. A value
of 0...±100 % correponds to an output signal of 0...±10 V (also see Chapt. 6.2 „Analog outputs").
ru.35 Analog output 2 / display before amplification
Adr.
0223h
This parameter shows the value of the analog signal ANOUT2 in percent before passing the characteristic amplifier (also
see Chapt. 6.2 „Analog outputs").
ru.36 Analog ouptut 2 / display after amplification
Adr.
0224h
This parameter shows the value of the signal given out on analog output ANOUT2 (terminal X2A.6) in percent. The value
of 0...±100 % corresponds to an output signal of 0...±10 V (also see Chapt. 6.2 „Analog outputs").
ru.37 Motorpoti - actual value
Adr.
2025h
The motorpoti-function in the KEB COMBIVERT imitates a mechanical, motor operated potentiometer. The control
occurs via 2 programmable inputs („poti up" and „poti down"). The display is limited by oP.53/54. The adjustment of the
motorpoti is done with the parameters oP.50...oP.59 (also see Chapt. 6.9.3 „Motorpoti"). By way of the bus the motorpoti
can be set to any chosen value between -100...100%. In addition to the inputs the motorpoti can be operated with the
keys „UP" and „DOWN". Then the rate of change is not constant.
Chapter Section Page
6 1 14
min max
-400 400
min max
-100 100
min max
-400 400
min max
0 100
min max
-100 100
Date Name: Basis
24.06.02 KEB COMBIVERT F5-G / B
Operating and Appliance Data
%
0.1
%
0.1
%
0.1
%
0.1
%
0.01
© KEB Antriebstechnik, 2002
All rights reserved
default
-
default
-
default
-
default
-
default
0