KEB COMBIVERT F5 BASIC Applications Manual page 108

Functional Description
HSP5 Watchdaog time
Sy. 9
Adr.
0009h
The HSP5 Watchdog-function monitores the communication of the HSP5-interface (control card - operator; or control
card - PC). After expiration of an adjustable time (0,01...10 s) without incoming telegrams, the response adjusted in Pn.5
is triggered. The value „off" deactivates the function.
Baud rate int. bus
Sy. 11
Adr.
000Bh
With the internal baudrate the transmission rate between operator and inverter is determined. Following values are
possible:
Value Baudrate
3 9,6 kBaud
4 19,2 kBaud
5 38,4 kBaud
Scope Timer
Sy. 32
Adr.
0020h
The scope timer generates a time period of 1 ms. This can be used by external programs, e.g. Scope, to represent time
patterns. The timer counts from 0...65535 and starts again with 0 after an overflow.
Control word high
Sy. 41
Adr.
0029h
The control word is used for the status control of the inverter via bus. The control word long (Sy.43) consists of the two
16 bit parameters control word high (Sy.41) and Control word low (Sy.50). The status word is bit-coded. The description
of the individual bits is found in Chapter 11.2.7.
Status word high
Sy. 42
Adr.
002Ah
With the status word the current condition of the inverter can be readout. The status word long (Sy.44) consists of the
two 16 bit parameters status word high (Sy.42) and status word low (Sy.51). The status word is bit-coded. The description
of the individual bits is found in Chapter 11.2.7.
Chapter Section Page
6 1 22
min max
0 (off) 10,00
min max
3 11
Value Baudrate Value
6 55,5 kBaud
7 57,6 kBaud
8 100 kBaud
min max
0 65535
min max
0 65535
min max
0 65535
Date Name: Basis
24.06.02 KEB COMBIVERT F5-G / B
Operating and Appliance Data
0,01
1
Baudrate
9 115,2 kBaud
10 125 kBaud
11 250 kBaud
1
1
1
default
s
0 (off)
default
-
5
default
-
0
default
- 0
default
-
0
© KEB Antriebstechnik, 2002
All rights reserved