Mitsubishi Eclipse 1990 Service Manual page 1370

AUTOMATIC TRANSAXLE
Planetary Gear
RIVET REMOVAL
(1) Shift the stopper plate to ensure that the rivet head does
not hit it.
NOTE
Make sure that the stopper plate claw is not at
the groove in the one-way clutch outer race.
(2) Using a pin punch, drive out the
REASSEMBLY SERVICE
B E A R I N G
(1) Install a new thrust bearing car&r.. sure
that it fits correctly in the spot faced carrier.
.
(2) Apply unsparingly to the inside surface of the
short pinion and attach the 17 rollers on the
TSB Revision