Mitsubishi Eclipse 1990 Service Manual page 1506

FRONT AXLE
GENERAL INFORMATION
The front axle
consists of a knuckle, front hub,
unit bearing and drive shaft, The unit bearing is
press-fitted to the front hub and bolted to the
kunckle. Also, the unit
row angular contact ball bearing. The drive shaft
CONSTRUCTION DIAGRAM
inner
SERVICE SPECIFICATIONS
Setting of boot length mm (in.)
Opening dimension of the When the
special tool
(in.)
Crimped width of the
Clearance between the
and the stepped phase of the B.J. housing mm (in.)
Wheel bearing end play mm (in.)
Wheel bearing breakaway torque Nm
LUBRICANTS
FWD
FWD
AWD
Inner
Outer dust seal
FWD
FWD
AWD
General
utilizes a double
Drive shaft
band (small) is 2.9
mm crimped
When the band (big) is
crimped
band mm (in.)
(larger diameter side)
.
Engine (Non-turbo)>
Engine (Turbo) and
Engine (Non-turbo)>
Engine (Turbo)
TSB Revision
Specification/Lubricants
has a tripod joint (T.J.) on the transaxle side and
(B.J.) on the wheel side. A center
a joint
bearing and an inner
in some models.
Knuckle
Standard value
3.2
2.4 2.8
0.1 1.55
Quantity (oz.)
105 (3.70)
Engine>
120 (4.23)
110 (3.88)
130
95 (3.35)
been adopted
hub
Limit
0.05
1 (9) or less
Specified lubricant
Repair kit grease
. grease
Repair kit grease
.