Mitsubishi Eclipse 1990 Service Manual page 1865

with entry system>,
Central door lock switch continuity check (Refer to
Door lock power relay continuity check (Refer to
Door lock power relay 2 continuity check (Refer to
Measure at the door lock power relay 1 connector
door lock power relay 2 connector
Disconnect the connector and measure at harness side.
Voltage between terminal
OK: Battery positive voltage
(2) Continuity between terminal (2) and ground
OK: Continuity
Measure at the door lock switch connector
(R.H.)
Disconnect the connector and measure at harness side.
L.H.: Voltage between terminal (I), (4) and ground
OK: Battery positive voltage
Voltage between terminal
OK: Battery positive voltage
(2) L.H.: Continuity between terminal (2) and ground
OK: Continuity
Continuity between terminal (7) and ground
OK: Continuity
Check the harness between the door lock actuator and the door
lock power relay and between the door lock actuator and the
door lock power relay 2. Repair, if necessary.
BODY
OK
and the
(7) and ground
OK
(L.H.) and
(5) and ground
OK
OK
TSB Revision
Door
Replace
Check the
power relay 1, and
power relay 2.
Check harness
ground, and
Repair, if necessary.
Check the harness between
door lock power relay 2. Repair; if
Check the harness between the door lock switch and the ground. .
Repair, if necessary.
NG
Replace
,
'the fusible and the;
link and door
if necessary.
the door lock power 1
the door relay
the
ground.
the door