Mitsubishi Eclipse 1990 Service Manual page 1487

AUTOMATIC TRANSAXLE OVERHAUL
Bearing cup
Lubrication hole
bearing retainer
I
Move side
A
proper shim.
bearing cup, and then press in using
new oil seal, press in using
and Installer Adapter (56)
dial indicator
check side gear end play at ring gear side and differential
case side.
NOTE
Side gear end play each side must be 0.025 to 0.330
mm
Four select thrust
0.81, 0.93, 1.07
i n c h ) .
If either side gear end play is not within
remove appropriate side gear thrust washer.
Measure existing thrust washer and replace with new
thrust washer that provides end play closest to center
of end play specifications.
TSB Revision
Differential
and Adapter
and Adapter
to inch).
are available.
mm
Bar
Cap
and