Mitsubishi Eclipse 1990 Service Manual page 1560

REAR AXLE
(2) Remove the snap ring with
remove the spider assembly.
Caution
Do not disassemble the spider assembly.
(3) In case foreign objects such as water or dust is mixed
in the grease, be sure to wash the spider assembly.
Caution
In case of having washed the spider assembly, when
assembling it, make sure to push enough grease be-
tween the spider axle and the roller so that grease
may not run out.
T.J.
(1) Wipe the grease off of the spline portion.
(2) Remove the
N O T E
If the boots are reused,
drive shaft spline so that the boots
when they are removed.
REASSEMBLY SERVICE
B.J. BOOT INSTALLATION
(1) Wrap plastic tape around the drive shaft spline.
(2) the drive shaft in'
(3) the inside of the B.J. and B.J. boot with the specified
grease.
NOTE
The grease in the repair kit should be divided in half
for use, respectively, at the joint and inside the boot.
Caution
The drive shaft joint uses
old and new or different types of grease.
TSB Revision
BOOT REMOVAL
boot and
grease: Repair kit grease
I
ring
around the
__
. . . ,
(2.66
grease. D not mix
O